The term that refers the switch does not keep information about the connection state, is _____________
The term that refers the switch does not keep information about the connection state, is _____________
A Circuit-Switched Network is made of a set of switches connected by physical______________
A Circuit-Switched Network is made of a set of switches connected by physical______________
The actual communication in a circuit-switched network requires ____________
The actual communication in a circuit-switched network requires ____________
Datagram switching is done at the _____________
Datagram switching is done at the _____________
In Circuit Switching, the resources needs to be reserved during the _____________
In Circuit Switching, the resources needs to be reserved during the _____________
Only one packet for each destination is allowed at each tick; if there is more than one, they wait for the next tick in ________________
Only one packet for each destination is allowed at each tick; if there is more than one, they wait for the next tick in ________________
Time Division Multiplexing inside a switch, is used by_____________
Time Division Multiplexing inside a switch, is used by_____________
A switch that connects n inputs to m outputs in a grid, using electronic micro switches at each cross point is called _____________
A switch that connects n inputs to m outputs in a grid, using electronic micro switches at each cross point is called _____________
Which frame completes the entries in the switching tables __________
Which frame completes the entries in the switching tables __________
The network where there is no resource reservation is called_____________
The network where there is no resource reservation is called_____________
Circuit switching takes place at the_____________
Circuit switching takes place at the_____________
A Virtual-Circuit Network (VCN) is normally implemented in the______________
A Virtual-Circuit Network (VCN) is normally implemented in the______________
A switch in a datagram network uses a routing table that is based on the ____________
A switch in a datagram network uses a routing table that is based on the ____________
Setup, data transfer, and connection teardown are three phases of ______________
Setup, data transfer, and connection teardown are three phases of ______________
The Asynchronous Transfer Mode (ATM) network is an example of____________
The Asynchronous Transfer Mode (ATM) network is an example of____________
A switch in a datagram network uses a ______________
A switch in a datagram network uses a ______________
Circuit Switched Networks are used in_______________
Circuit Switched Networks are used in_______________
The identifier that is actually used for data transfer is called the ______________
The identifier that is actually used for data transfer is called the ______________
In a packet-switched network, resources are allocated ___________
In a packet-switched network, resources are allocated ___________
The phase where the establishment of the channels takes place is_____________
The phase where the establishment of the channels takes place is_____________
Three methods of switching are _______________
Three methods of switching are _______________
The routing processor searching for the routing table is called______________
The routing processor searching for the routing table is called______________
The port that performs the physical and data link functions of the packet switch is called _______________
The port that performs the physical and data link functions of the packet switch is called _______________
Virtual-Circuit Networks and datagram networks are the sub categories of _____________
Virtual-Circuit Networks and datagram networks are the sub categories of _____________
Switching in the Internet is done by using the datagram approach to packet switching at the _______________
Switching in the Internet is done by using the datagram approach to packet switching at the _______________