1000Base-LX has used two wires for long wave are________________
1000Base-LX has used two wires for long wave are________________
A source address is always a _______________
A source address is always a _______________
Protocol Data Unit (PDU) is similar to______________
Protocol Data Unit (PDU) is similar to______________
In half duplex mode of MAC sublayer the stations are connected via ____________
In half duplex mode of MAC sublayer the stations are connected via ____________
The original Ethernet was created in_____________
The original Ethernet was created in_____________
Preamble contains ____________
Preamble contains ____________
In 10Base5, the maximum length of the coaxial cable is ________________
In 10Base5, the maximum length of the coaxial cable is ________________
The terms that control the flow and errors in full duplex switched Ethernet is called____________
The terms that control the flow and errors in full duplex switched Ethernet is called____________
The field of the MAC frame that alerts the receiver and enables it to synchronize is known as ______________
The field of the MAC frame that alerts the receiver and enables it to synchronize is known as ______________
The maximum length of optical fiber in 10BaseF is ______________
The maximum length of optical fiber in 10BaseF is ______________
The maximum length of 10GBase-L in Gigabit ethernet implementation is __________
The maximum length of 10GBase-L in Gigabit ethernet implementation is __________
In 10Base2, the cable is ______________
In 10Base2, the cable is ______________
There is no need for CSMA/CD in___________
There is no need for CSMA/CD in___________
The Computer Society of the IEEE started a project named project 802 in _______________
The Computer Society of the IEEE started a project named project 802 in _______________
The Ethernet frame contain ______________
The Ethernet frame contain ______________
Acknowledgments of the frames must be implemented at the ________________
Acknowledgments of the frames must be implemented at the ________________
A destination address can be__________
A destination address can be__________
The term that is used to set standards to enable intercommunication among equipment from a variety of manufacturers is called ____________
The term that is used to set standards to enable intercommunication among equipment from a variety of manufacturers is called ____________
In the full duplex mode of gigabit Ethernet, there is no ____________
In the full duplex mode of gigabit Ethernet, there is no ____________
The sublayer of data link layer that frames the data received from upper layer is called______________
The sublayer of data link layer that frames the data received from upper layer is called______________